2×1 power lead · 50 cm
50 cm power lead for internal cabinet wiring.
- Length
- 50 cm
Purpose and capabilities
Supplier-listed 50 cm LED accessory lead CP-2150 is marked “2×1”. Connector pinout, polarity and current rating are not published; match it to the exact module and PSU before use.
Where it is used
Local supply wiring for matching low-voltage LED cabinet parts.
Signal path
Confirm polarity and connector fit against the exact equipment revision.
Check before selecting
Do not assign to mains wiring or calculate current capacity without a datasheet.
Technical specifications
Values include conditions and sources where available. Configured systems may differ from the base model.
Variant and interface
| Parameter | Value |
|---|---|
| Exact model | CP-2150Source |
| Cable marking | 2×1Supplier listing marking only.Source |
Dimensions and supply
| Parameter | Value |
|---|---|
| Length | 50 cmSource |
Model reviews
Reviews relate to the model. Used equipment condition and contents must be checked separately.
Loading reviews…
Compatibility and system composition
Device relationships depend on variant, revision, firmware and operating mode.
A matching brand or connector does not prove compatibility. Electrical and logical requirements and the complete signal chain must be checked.
Engineering status
Engineering review pending; full chain unapproved
There are no confirmed pairings for this exact SKU yet. An engineer will review it.
Before confirming a project
- Polarity, connector type and current rating
- TOUCHLED stock and lead time
Documents and software
Match software and firmware to the exact hardware and revision. Check the official source before installation.
