NovaStar MON300
A control system accessory. Verify purpose, power requirements and connections in its model-specific documentation.
Purpose and capabilities
NovaStar MON300. A control system accessory. Verify purpose, power requirements and connections in its model-specific documentation.
- 01The factory document identifies the MON300 role in the signal chain.
- 02Specified dimensions: 144.0mm × 91.5mm × 22.5mm. Check installation space and cooling.
MON300 in the display system
NovaStar MON300 serves as a control system accessory in the signal chain. This page describes the exact MON300 variant; confirm package contents, hardware revision and availability before ordering.
Capacity and interfaces without hidden assumptions
Compatible equipment → accessory
What to verify before specifying
The factory specification documents this model, not every possible device pairing. An exact quote needs sending and receiving models, hardware revisions, firmware versions, hub pinout, module drivers and port plan. Until those are reviewed, the configurator keeps the chain preliminary.
- No approved pairing with a specific TOUCHLED LED module.
- Actual configuration, revision and firmware must be confirmed before supply.
Where it is used
A control system accessory. Verify purpose, power requirements and connections in its model-specific documentation.
Signal path
- 01Compatible equipment
- 02accessory
Check before selecting
Verify the exact hardware revision, firmware and complete signal chain. Maximum specifications do not guarantee simultaneous operation of all features. Catalogue inclusion does not confirm stock or rental availability.
Technical specifications
Values include conditions and sources where available. Configured systems may differ from the base model.
Physical
| Parameter | Value |
|---|---|
| Dimensions | 144.0mm × 91.5mm × 22.5mmSource · V2.2.0 · 规格参数 / Specifications |
Additional parameters
| Parameter | Value |
|---|---|
| Rated power | |
| Voltage monitoring channels | |
| Fan monitoring channels | |
| Supply voltage | |
| Receiving cards named in introduction | MRV320 / MRV560LED and ribbon cable detection require supported drivers and a matching HUB board.Source · V2.2.0 · 简介 / 特性 / 接口 — Introduction / Features / Interfaces |
Model reviews
Reviews relate to the model. Used equipment condition and contents must be checked separately.
Loading reviews…
Compatibility and system composition
Device relationships depend on variant, revision, firmware and operating mode.
A matching brand or connector does not prove compatibility. Electrical and logical requirements and the complete signal chain must be checked.
Engineering status
Engineering review pending; full chain unapproved
There are no confirmed pairings for this exact SKU yet. An engineer will review it.
Alternatives
For comparison, not a direct replacement without verification.
NovaStar NS060
Compare specifications; not a verified replacement.
novastar-mfn300
Compare specifications; not a verified replacement.
NovaStar MTH310
Compare specifications; not a verified replacement.
Before confirming a project
- No approved pairing with a specific TOUCHLED LED module.
- Actual configuration, revision and firmware must be confirmed before supply.
Documents and software
Match software and firmware to the exact hardware and revision. Check the official source before installation.
