Power cable 2×1 · 35 cm
Short two-conductor lead for LED cabinet power wiring.
- Length
- 35 cm
Purpose and capabilities
35 cm power lead marked “2×1” by the supplier. The photo shows a two-conductor cable with a connector; verify pin assignment, current rating and exact connector against the module and actual delivery.
Where it is used
Local low-voltage wiring after checking connector fit and polarity.
Signal path
Check polarity and connector function against the board documentation.
Check before selecting
Do not use for 230 V mains or current sizing without a verified specification.
Technical specifications
Values include conditions and sources where available. Configured systems may differ from the base model.
Variant and interface
| Parameter | Value |
|---|---|
| Cable marking | 2×1Supplier title marking.Source |
Dimensions and supply
| Parameter | Value |
|---|---|
| Length | 35 cmSource |
Model reviews
Reviews relate to the model. Used equipment condition and contents must be checked separately.
Loading reviews…
Compatibility and system composition
Device relationships depend on variant, revision, firmware and operating mode.
A matching brand or connector does not prove compatibility. Electrical and logical requirements and the complete signal chain must be checked.
Engineering status
Engineering review pending; full chain unapproved
There are no confirmed pairings for this exact SKU yet. An engineer will review it.
Before confirming a project
- Polarity, connector type and current rating
- TOUCHLED stock
Documents and software
Match software and firmware to the exact hardware and revision. Check the official source before installation.